Checking Visability

[+Kapitein Haak]

Currently i am making a cartridge to give suppourt on a long hike, on every turn the cartridge will tell how to hike further directionwise.

I can make the zones but when i click the visible checkbox on the right of the sceen and save the zone the visablity option is not saved.

The effect is that in the emulator i see the made zones but no events, messages in this case, will occur.

I work on Windows Vista SP 1 premium. I also have downloaded the newest builder after de-installing the old one.

 

Anybody knows about this problem?

 

Kapitein Haak.

[Ranger Fox]

The messages should have shown up in response to an event. Can you clarify what you mean when you say, "i see the made zones but no events, messages in this case, will occur"? [sic]

[+Kapitein Haak]

When i check the "visible" checkbox and save it, then re-open the zone the checkbox is unchecked. Therefor the event is not triggered when entering the zone. I set it to trigger on entering the zone however. So you can see the zone but the message won't appear due to the fact that the cartridge does not save the checked checkbox.

 

Greatings Haak.

 

P.s. I see that the checkbox says Active so not Visible. But still same problem.

Edited September 13, 2008 by Kapitein Haak

[+Kapitein Haak]

After changing the notation of coördinates in the preference screen i got it working now but then;

After adding about 30 zones i was ready and saved the cartridge. I try opening the cartridge (lua) again then i get the following message:

 

 

I don't know whats wrong now, is it possible that anybody looks in the backupfile? here it is. (tried to add the file but seems impossible)

 

Thx already Kapitein Haak.

 

Ps I found it, it was the deleting a zone leftover that caused it

Edited September 16, 2008 by Kapitein Haak