Wherigo - Navigating to ZOnes problem

[+Scara-z]

Well, I have been sitting on a Wherigo Test for like 2 days, made zones and characters and everything, tested it on Emulator, where it worked perfectly with dragging of the little man to the next zone, so I tried it in field with my own GPS. My problem is, if I go to the Start, I get this message, everything works, and the next Station is set Active (true) automatically. But it doesn't appear under Positions or You See. I'd like Wherigo to navigate me (per compass or so) to the next Station - how the Hell do I do it? Or did I just make a mistake t setting the zones to 'active'? If yes, then what?

I totally appreciate any help!

[+Team Peredox]

I'm new at building carts, but this is my understanding:

 

How far away is the next zone, and what is its 'distant' setting? Even though it's 'visible' and 'active', you may not see it because it's too far away (i.e. out of range). Either raise the 'distant' setting or set it to always be in range.

[+TheHarvesters]

I'm new at building carts, but this is my understanding:

 

How far away is the next zone, and what is its 'distant' setting? Even though it's 'visible' and 'active', you may not see it because it's too far away (i.e. out of range). Either raise the 'distant' setting or set it to always be in range.

A zone needs to be both actuive *and* visible to be seen in the locations section of the interface.

 

If you are a distance away from it, the locations section will show how far and point the direction too.

[+sTeamTraen]

Most beginners' questions about zones can be fixed by setting the "Distance Range" of the zone to -1.