nc-ghost Posted June 25, 2002 Share Posted June 25, 2002 I have used the etrex for a couple of days now but not sure how to input the coordinates so I find them. Do you have to buy the interface cable and use some software? If so where is a cheap place to get both? Thanks Quote Link to comment
+nscaler Posted June 25, 2002 Share Posted June 25, 2002 Push and hold the enter key. This will mark your location. Move cursor to "OK?", push enter. Now bring up the waypoints, move cursor to the one you just marked, push enter. Move cursor till on coords, push enter. Change coords. Name can be changed same way. Good deal on cables on Ebay. Got data cable for $15 w shipping. nscaler "Anyone not here, raise your hand!". Quote Link to comment
nc-ghost Posted June 25, 2002 Author Share Posted June 25, 2002 thanks, I got it now Quote Link to comment
+mrp Posted June 25, 2002 Share Posted June 25, 2002 You can skip a couple of steps nscaler talks about. After you hold the enter key to mark a new waypoint, you can use the up and down to move to the coordinates, press enter, and then change them right there, the same goes for the icon and the name. -- Mitch Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.