Magellan eXplorist GC - loading PQs

[+geecmom]

Is there a way to load a whole pocket query into the eXplorist GC at once? With my 60 Csx I run my pocket queries through GSAK and load my GPSr from there. Can I do that with the eXplorist GC also?

[+RubioHanna Clan]

I was going to use GSAK, since I use that for my Etrex, but dragging the file and dropping it into the geocache folder is easier.

 

Clarification: when you connect the Magellan GC to your computer it will show up as a drive (similar to a jump drive). You can drop the extracted pocket query file directly into the folder labeled Geocache under the Magellan drive. Hope this helps!

[+geecmom]

I was going to use GSAK, since I use that for my Etrex, but dragging the file and dropping it into the geocache folder is easier.

 

Clarification: when you connect the Magellan GC to your computer it will show up as a drive (similar to a jump drive). You can drop the extracted pocket query file directly into the folder labeled Geocache under the Magellan drive. Hope this helps!

 

 

Thanks! I'll try that and see which I prefer, now that I have downloaded the newest GSAK with GC support, too.

[+TeamSenavinin!]

Is there a way to load a whole pocket query into the eXplorist GC at once? With my 60 Csx I run my pocket queries through GSAK and load my GPSr from there. Can I do that with the eXplorist GC also?

 

For step by step instructions, this might help:

 

Getting PQs onto your Magellan GC

 

It's Mac specific, but should work the same way for PCs.

[+EScout]

If you have GSAK, use it because of the filters.

You can also load the PQ directly, or use VantagePoint.

Edited September 14, 2010 by EScout