Pocket Queries defect?

[+Haferle]

Hi folks,

 

my newly arrived output of a pocket query doesn't show up in my oregon 300 - only the waypoints.

The december output of just the same PQ on the other hand was perfectly ok. Any clues?

 

Thanks, Haferle

[+Teddy2k]

Sounds like you only loaded the '#######-wpts.gpx' file. This file only contains child waypoints for the geocaches. In order to get the geocaches themselves, you need to load the other file as well ('#######.gpx').

[+Wacka]

I am tweaking some unrun PQs to cover the area. I set them up with the default 100 miles. I want to set the distance to 80 so that I can have less PQs. I change it and it shows 80s when saved, but the preview shows caches to 100 miles. I have cleared the cache and also closed and reopened Firefox, but it persists.

[+pppingme]

I am tweaking some unrun PQs to cover the area. I set them up with the default 100 miles. I want to set the distance to 80 so that I can have less PQs. I change it and it shows 80s when saved, but the preview shows caches to 100 miles. I have cleared the cache and also closed and reopened Firefox, but it persists.

Have you gone back in to make sure it saved correctly? That form is quite buggy sometimes.

[+Haferle]

Sounds like you only loaded the '#######-wpts.gpx' file. This file only contains child waypoints for the geocaches. In order to get the geocaches themselves, you need to load the other file as well ('#######.gpx').

 

Thanks for your reply. Yes, I loaded both files as suggested, but no difference. However, after ordering a refreshed output of the same PQ another day, everything went fine. Probably YAM (yet another mystery)