Barometer scale wrong on 60csx/76csx

[Forkeye]

Can someone verify if I am right or wrong about this.Select either barometer mode,set the horizontal scale to 6 hrs,that is 6hrs for 4 squares on the graph?That means one square should be 1.5hrs. 1.5x4=6.Now press enter and in the lower left it shows 1 square=1hr???Now scroll the red cursor over and take the time reading from one grid lines,now scroll over to an adjacent grid line and note the time,the differance is 1.5hrs between grid lines not 1hr as shown.All other horizontal barrometer scale settings work out fine,but not this one.

[+Prime Suspect]

Can someone verify if I am right or wrong about this.Select either barometer mode,set the horizontal scale to 6 hrs,that is 6hrs for 4 squares on the graph?That means one square should be 1.5hrs. 1.5x4=6.Now press enter and in the lower left it shows 1 square=1hr???Now scroll the red cursor over and take the time reading from one grid lines,now scroll over to an adjacent grid line and note the time,the differance is 1.5hrs between grid lines not 1hr as shown.All other horizontal barrometer scale settings work out fine,but not this one.

Are you talking about pressure plotting, or elevation plotting?

Edited April 12, 2008 by Prime Suspect

[Forkeye]

Pressure plot,either Barrometric or ambient pressure.

[Forkeye]

On the altimeter times there are also 2 times that dont work out,maybe they are only intended to be approximations,due to space requirments for the print.