Jump to content

Vintage Sony GPSr


Recommended Posts

OK boys & girls,

I have for sale a vintage SONY PYXIS IPS-360 GPSr.

 

I originaly purchased this unit NIB, from a friend of a friends widow at a garage sale. Her husband purchased this GPSr to use on thier sailboat, but then became ill, and passed away! So it was NEVER used by him. I have had it out of the box maybe a dozen times to play around with it, and it worked great for me. It has never realy been used, and is in perfect condition! This unit comes with the original box, case, and all of the original accessories that were in the box when it was purchased!

 

sonygps1.jpg

 

sonycase.jpg

 

sonybox.jpg

 

Now, unfortunately, this GPSr has succumb to an internal defect that has caused the LCD screen to go blank. The unit does power-up, but the LCD screen stays blank. I have found a a technical document that explains how to fix this problem, and it explains in detail, how to repair this vintage GPSr. So if you are good at repairing electronics, it should be a piece-of-cake to repair it!!!

 

Here is the text of the document, and a link to it online:

 

http://hardware.mcse.ms/message257419.html

 

Just in case someone else would like to save one of these old GPSs from

the trash, if it has the apparently blank LCD problem...

 

My unit had the symptom of no LCD display (like it was turned off), but

the unit properly beeps when powered on, and the POS LED properly

lights.

 

I found that the -5V LCD drive voltage had failed which causes the

contrast to be turned off. The -5V inverter is on the small daughter

PCB that is around the antenna connector on the lower main PCB.

 

Remove the battery cover.

 

Remove the battery cover gasket, then remove the 4 screws, then remove

the back GPS cover

 

Remove the top PCB (4 screws) and carefully unfold the ribbon cable.

 

Remove the lower PCB (4 screws) and pry the PCB out from the light

button side 1st, being careful not to mess up the button rubber pieces.

 

You will see a small daughter PCB under this PCB that surrounds the

antenna connector. This small PCB also has the beeper on it. Unplug

this PCB as this is the PCB with the -5V inverter on it.

 

Replace the two electrolytic SMT caps that are on either side (above

and below) of the 8 pin SOIC labeled "7600" which is a switching power

supply controller/inverter. I replaced the caps with SMT tantalums

(remember Tant polarity markings are opposite of the AL electrolytics).

Reassemble and test.

 

 

In its day, (the early 90's) this unit retailed for over $1000.00........I originaly paid $100.00 bucks for this Vintage GPSr, so if you think you can fix it, make me an offer???

 

Email me at: xlobsterman@hotmail.com

Link to comment

I am attending an auction tomorrow; they have one of these for sale.

 

Does anyone know what batteries they take or how to install them? The only info I've found is the unit is accurate to only 1,000ft!

 

edit i found another small bit of info:

Sony Pyxis IPS-360:

4 channels, auto fix only, water resistant, no NMEA interface, 99

waypoints, dist/bearing to wp, speed, ETA at wp, XTE, track plot-

ter, lock-on time 157 sec, battery life 20 MINUTES, price ST#725.

Edited by jcrosser
Link to comment

Does anyone know what batteries they take or how to install them? The only info I've found is the unit is accurate to only 1,000ft!

 

This unit takes 4 AA batteries, that are installed by removing the cover on the rear of the unit! It also has a 12v cig. adapter.

 

Also, I checked this unit with one of my garmin GPSrs, and the units had almost the same coordinates! So, IMO, the accuracy was not what you quoted!!

Link to comment

you may get $50 if you post it on ebay.

 

Hey QJ,

that is where it will be going if I do not sell it here. I just wanted to offer it here first, because there was quite a bit of interest in the unit when I posted about it in some other message threads here concerning the begining of the GPS era..................... :)

 

I would take $50.00 bucks for it here, and I will pay shipping! :o

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...