explorist 500 LE help

[backdraft64]

I have try to update my explorist to the new version and now everytime i try to open it it is written UNIT CURRENTLY CONTAIN NO MAP! INITIALING MAP UPLOAD. And nothing else happen and it froze on this message .

Anything i can do?

 

Thank You in advance

backdraft

[+embra]

See "how do I restore my basemap" in the mapping software section of the FAQs in my sig line.

[backdraft64]

I am not able to do anything whit My GPS when i open it goes directly to this message...?????

[+embra]

Sorry, I see our FAQs are a little incomplete on this problem. You first will have to go to the service function menu as described in that section of the FAQs and enter #95 (erase serial flash memory). After you do this, then when you turn the GPS on with the USB cable connected, the computer should recognize the GPS and connect so you can follow the directions I first pointed you towards.

 

I'll try to re-write that section so all the information is in one place. Replacing the basemap had come up before when people had to escape the endless NAND loop, which required clearing serial memory. The basemap replacement was a side effect in that solution, not the presenting problem.

 

Please let me know if you need any more specific information, and how you make out.

Edited March 25, 2007 by embra

[backdraft64]

[i have foud how to do the reset but still have the same message when i turn it on. Unit currently contain no maps initialing map upload .....

 

Embra what is the sig line?

 

Thank you backdraft