Jump to content

Explorist 100


elcud
Followers 0

Recommended Posts

Just back up ALL of you data on the computer before you mess with it.

 

I lost all my geocaches- close to 100, after the thing did a factory reset after freezing up. I had to take the battery out. Good thing I had all of them in the computer to upload again (yeah I bought the cable for the 100). Imagine the horror of putting them all back in by hand.

 

My advice is not to do it. But if you want to play around with it, make sure you can upload all your data back into the unit IF it does a factory reset.

 

I found the easter egg on eBay.

 

from the site:

In order that you can use a data cable, you have to enable the com port by doing the following:

Press Menu, and then the joystck RIGHT. LEFT, RIGHT LEFT,

A service function menu appears, change to 41, press ENTER, and choose NMEA V 2.1 GSA.

Once again Press Menu, and then the joystck RIGHT. LEFT, RIGHT LEFT,

Change the service function menu to 40, and choose 4800 baud rate.

The GPS is now ready to be connected.

 

Enjoy

Link to comment
Guest
This topic is now closed to further replies.
Followers 0
×
×
  • Create New...