Hello to all:
Seems like we have a lot of 60cs fans out there, which is great.
I have an auto-route problem in using my City Select and transferring that route to my 60cs.
My 60cs unit software is at 4.00. I've tried City Select at both 6.8 and 6.9.0.2 Beta level with the same results. Here's whats happening: I create a route from point "a" (home) to point "b" (destination) within City Select. Closer to point "b", there is a section of interstate I don't want to go on and create a "route avoidance" in City Select, recalculate the route, and the result is the the route I wish to travel. I transfer the maps, waypoints and route to my 60cs without a problem. Start out on my trip, connect to the units above, go to "routes", select the route I created and transferred from City Select, click on “navigate”, it does some “calculating”, and everything seems ok.
Here's the problem: my purple route line is not going the way in which it was setup in City Select. It is not honoring the "route avoidance". But... in looking at the “list of turns” in the "Active route" page, those directions are correct, listing turn by turn directions of the route I wish to take. The reason I am aware of this discrepancy, is that when I was taking the route last weekend, when I got to the junction of where I set up the “route avoidance”, the unit told me to stay on the “route avoidance” road. I didn't because I knew which way I wanted to go, and the 60cs was beeping and recalculating all over the place. I've tried to match route settings in the 60cs to the City Select but that makes no difference. Bottom line... I want the route that I use in my 60cs and transferred from City Select to be exactly the same as the route that I've created in City Select. Any ideas how I accomplish this. It must be some setting that I have incorrect, I'm guessing in the 60cs?
Sorry for the length and appreciate the help.
