Thanks for your help, but I can't seem to change the Geocache line in the Active Setup to read... SD/Geocaches. This may be a silly question, but I can't seem to figure out how to hit select.. I've tried the jostick, as you would normally do to enter, but all it does is just move back up. This is so frustrating!! Any additional advice?
Yes, as you say, you should use the joystick to enter. Try this:
After “Select File” (step 5 above)
You should see
…l Memory\Geocaches\ (this is the header; you can't select it)
Up One Level
list of files (if you’ve saved any to your internal memory)
Highlight “Up One Level” and hit Enter
You should now see
Internal Memory\ (again, this is the header)
Up One Level
Background Maps
Etc.
Highlight “Up One Level” and hit Enter
You should now see:
Internal Memory
SD Card
Highlight “SD Card” and hit Enter and you should see
SD\Geocaches\ (header)
Up One Level
Files you’ve loaded to your SD card
Now you can toggle down and select the file you want as your default.
I just figured out my problem... There's a difference between a file and a folder in this GPS. The only way it will allow me to select the POI default is to select a file, not a folder. All of my waypoints are stored within folders, not files. And, after reading the user manual in order to create a file in my GPS, I have to select "create a new file" in my GPS, which I don't have. Hmmm, I'm getting closer. Are there any other ways to create a file if the "create a file" file is not on my gps?